Since the sink is a sanitary device that ensures the intake of used water and its direction into the sewer system, work on its installation is carried out, as a rule, after the installation of the water supply system and the drainage system.
Practice shows that in order to ensure comfortable use of the sink, the height of its location from the floor should be about eighty-five centimeters, while there is no point in fixing this product at a slightly lower height.
The same requirements apply to kitchen sinks. These standards should be adhered to not only when buying and installing hinged models of sinks and sinks, but also those that are sold in a retail network in a place with pedestals.
Before starting work on installing the sink, you should decide on the place of its attachment, based on the possibilities of connecting taps or mixer, the location of the drain hole, etc..
In principle, the connection points must already be determined during the installation of the piping and sewerage systems, but there are various options. After the place of installation of the sink is determined, it is necessary to choose the method of its fastening. For this, brackets, a pedestal, a curbstone, special shelves, etc. can be used..
At the next stage, provided that there are no peculiarities, the recommended height of the sink from the floor is measured, and a line is drawn at the recommended height using a pencil or marker. It will indicate the top edge of the product..
On its back side there is a plane of abutment to the bearing surface. Having measured its width, the resulting value is laid down along the wall, counting from the first line. In this case, you should pay attention to the fact that both lines are strictly horizontal..
After that, the distance between the holes for attaching the brackets located on the back plane of the sink is measured. The resulting value is indicated on the upper line. To ensure symmetry, you can use the product drain neck as a guide..
Then, they retreat from the top of the line by the size of the height between the upper edge and the center of the fastening hole, holes for dowels are made in the wall, and plugs are installed in them.
Next, the brackets are attached to which the hanging sink will be installed. Using special open-end wrenches from the bottom side of the fastening of the product are tightened, and in the future, the mixer, siphon, etc. are installed. etc.
And if you want to continue to make repairs with your own hands, then you just need to visit the diy portal. On the portal you will find a lot of useful information, such as a master class on laying laminate flooring, or self-installation of a false ceiling and much, much more..
